Tire chains -38 changing wheels and tires -38 – NISSAN 2008 Titan User Manual

Page 344

Advertising
background image

If you install snow tires, they must be the same

size, brand, construction and tread pattern on all

four wheels.
For additional traction on icy roads, studded tires

may be used. However, some U.S. states and

Canadian provinces prohibit their use. Check

local, state and provincial laws before installing

studded tires. Skid and traction capabilities of

studded snow tires on wet or dry surfaces may be

poorer than that of non-studded snow tires.

TIRE CHAINS

CAUTION

Tire chains/cables should not be installed

on P275/60R20 size tires. Installation of

the tire chains/cables on P275/60R20 size

tires will cause damage to the vehicle. If

you plan to use tire chains/cables, you

should install P265/70R18 size tires on

your vehicle.

Use of tire chains may be prohibited according to

location. Check the local laws before installing

tire chains. When installing tire chains, make sure

they are the proper size for the tires on your

vehicle and are installed according to the chain

manufacturer’s suggestions. Use only SAE

class “S” chains. Class “S” chains are used on

vehicles with restricted tire to vehicle clearance.

Vehicles that can use Class “S” chains are de-

signed to meet the minimum clearances between

the tire and the closest vehicle suspension or

body component required to accommodate the

use of a winter traction device (tire chains or

cables). The minimum clearances are determined

using the factory equipped tire size. Other types

may damage your vehicle. Use chain tensioners

when recommended by the tire chain manufac-

turer to ensure a tight fit. Loose end links of the

tire chain must be secured or removed to prevent

the possibility of whipping action damage to the

fenders or underbody. If possible, avoid fully load-

ing your vehicle when using tire chains. In addi-

tion, drive at a reduced speed. Otherwise, your

vehicle may be damaged and/or vehicle handling

and performance may be adversely affected.
Tire chains must be installed only on the

rear wheels and not on the front wheels.
Do not use tire chains on dry roads. Driving with

chains in such conditions can cause damage to

the various mechanisms of the vehicle due to

some overstress.
Use only the 2WD range when driving on clear

paved roads.

CHANGING WHEELS AND TIRES
Tire rotation

NISSAN recommends rotating the tires

every 7,500 miles (12,000 km).
See “Flat tire” in the “In case of emer-

gency” section in this manual for tire re-

placing procedures.
As soon as possible, tighten the

wheel nuts to the specified torque

with a torque wrench.

WDI0258

8-38

Maintenance and do-it-yourself

REVIEW COPY—

2008 Titan (tzw)

Owners Manual—USA_English (nna)
10/12/07—debbie

Advertising