Active brake limited slip (abls) system, If so equipped) -30 – NISSAN 2008 Titan User Manual

Page 280

Advertising
background image

WARNING

Do not pump the brake pedal. Doing so

may

result

in

increased

stopping

distances.

Normal operation

The ABS operates at speeds above 3 - 6 MPH (5

- 10 km/h).
When the ABS senses that one or more wheels

are close to locking up, the system electronically

controls the pressure applied to each brake.
This action is similar to pumping the brakes very

quickly. You may feel a pulsation in the brake

pedal and hear a noise from under the hood or

feel a vibration from the actuator when it is oper-

ating. This is normal and indicates that the ABS is

operating properly. However, the pulsation may

indicate that road conditions are hazardous and

extra care is required while driving.

Self-test feature

The ABS includes electronic sensors, electric

pumps, hydraulic solenoids and a computer. The

computer has a built-in diagnostic feature that

tests the system each time you start the engine

and move the vehicle at a low speed in forward or

reverse. When the self-test occurs, you may hear

a “clunk” noise and/or feel a pulsation in the brake

pedal. This is normal and does not indicate a

malfunction. If the computer senses a malfunc-

tion, it switches the ABS off and illuminates the

ABS warning light on the instrument panel. The

brake system then operates normally, but without

anti-lock assistance.
If the ABS warning light illuminates during the

self-test or while driving, have the vehicle

checked by a NISSAN dealer.

● ABLS is a form of traction control using

sensors from the Anti-lock Brake System

(ABS) to transfer power from a slipping drive

wheel to a wheel with more traction. The

ABLS system applies braking to the slipping

wheel, which helps redirect power to an-

other wheel.

● On 4WD models the ABLS system operates

in both 4H and 4LO modes. If 4WD mode is

engaged, the ABLS system will operate for

both drive axles. On 2WD vehicles, the

ABLS system operates on the drive axle

only.

● The ABLS system is always ON unless the

system detects brake pad overheating. If

high brake pad temperature is detected, it

will turn OFF, but normal brake function will

continue. ABLS will function even when the

VDC system (if so equipped) is turned OFF.

WARNING

The ABLS system provides increased trac-

tion, but will not prevent accidents due to

abrupt steering operation or by careless

driving or dangerous driving practices.

Reduce vehicle speed and be especially

careful when driving and cornering on

slippery surfaces, and always drive

carefully.

ACTIVE BRAKE LIMITED SLIP (ABLS)

SYSTEM (if so equipped)

5-30

Starting and driving

REVIEW COPY—

2008 Titan (tzw)

Owners Manual—USA_English (nna)
10/12/07—debbie

Advertising