MIPRO act707s-ii(2ce149)b - Manual (Page 12)

BELT PACK TRANSMITTER BELT PACK TRANSMITTER
2 0 21
1. PARTS NAMES AND FUNCTIONS
(Fig.1)
1. AF Input Jack: Connects to a lavaliere or headset microphone. (See 5 ways
of connection on AF Input Connections)
2. Power Switch: Tums power "on" and "off" of the transmitter.
3. Battery Status Indicator: Indicates the power on / off and battery status.
(a) When power switch is turned on: The LED indicator flashes briefly,
indicating normal battery status.
(b) When RED light illuminates at either power on or during usage: The
battery level is low, therefore, a new battery replacement is thus necessary.
4. Transmitting Antenna: 1/ 4 transmitting antenna.
5. Transmitter Housing: Packages the PCB and battery.
6. Functions of LCD Display
7. ACT Signal Receptor: Receiving ACT signal and adjusting frequency
automatically.
8. Gain Control: Adjusts the desirous input gain.
9. GT/MT Level Selector: Switch GT position for electric guitar usage and "Line
In". Gain Control is irrelevant for "GT". Switch to "MT" for condenser
microphone or wired microphone. Gain Control works in "MT" for input
sensitivity adjusting.
10.Battery Compartment and Cover: Accommodates two 1.5V(AA) batteries.
11.Detachable Belt Clip: Allows 360 degrees rotating to suit transmitting angles.
To detach simply use a screwdriver at a 45 degree angle to unfasten. see
diagram.
λ
1
2
11
3
5
8
9
7
4
6
ACT S E RIES
GROUP CHANNEL BAT
GAIN M TG T
1 0
OFF ON BATT.
LOW