MIPRO act707s-ii(2ce149)b - Manual (Page 8)

1 2 13
ACT SINGLE CHANNEL WIRELESS RECEIVER ACT SINGLE CHANNEL WIRELESS RECEIVER
(5) NAME: Indicates or setups the name ofcurrent channel user. (6) REMO: Indicates or setup the receiver address and status o f r emote controlling.
A. Operating Procedures.
A. Operating Procedures.
B. How to Operate?
B. How to Operate?
a. Maximum 6 characters are allowed (Select from capitalized English letter, numbers,
+ - x /, and space).
b. Push "UP" or "DOWN" button into setup m o d e and the character on the far left will
start blinking. (There will be no blinking if there is nocharacter in the specific space).
c. Push "UP" or "DOWN" button to select desired character and confirm bypushing
the "MENU" button. Once confirmed, the next character will start blinking a n d ready
for setup.
d. Repeat step c until ALL 6 characters are set.
a. ACT-BUS interface is adapted for MIPRO Wireless Receiver Module. With MIPRO
Interface Converter and Monitoring Software, up to 64 receiver modules can be
remote-controlled simultaneously via a PC.
b. Address can be set within the range of 01-64. Under remote control mode, each
receiver module MUST has its own address. If 2 different receiver modules are
using the same address, it will cause confliction and result in monitoring error.
However, if not under remote control mode, operation will remain normal e v e n if 2
different receiver modules are using the s a m e address.
c. In remote control mode, "ON" will b e s h o w n i n t h e L C D d i s p l a y p a n e l a n d the
number next to the message is the address of t h e receivermodule. However,
"OFF" will be shown i s thesystem is not remotely linked to t h e PC.
d. Push "UP" or "DOWN" button to change receiver address and verify by pushing the
"MENU" button.
Save
NAME MENU A MENU
NEXT
EXIT A MENU
DOWN UP
DOWN UP
save
REMO MENU 64 EXIT MENU
DOWN UP
ACT
MENU
GROUP
SCAN
ACT
MENU
GROUP
SCAN