Dish Network Duo ViP 222 - Manual (Page 75)

Remote Controls
67
Controlling Other Components
3
On the DISH Network remote, press and
hold the mode button for your equipment
for about three seconds until all the mode
buttons light up, and then release it. Your selected mode button will blink. For
example, if you want to program TV mode on
the DISH Network remote to control your TV,
hold the TV button down for three seconds.
4
To start learning commands for this mode:
• If you've found a code for that
device, first program the code.
Now press and release RECALL,
then press and hold RECORD for
about three seconds.
• If you have not programmed a
code for that device, press and
hold RECORD for three seconds.
To find and program the device code, use the
instructions for Setting Up Using Device Code
Tables or Setting Up Using Device Codes
Scan.
The mode button that you selected in step 3
should remain lit while learning. If the light goes
out, start over the learning process with step 3.
5
Point the front of the original device remote
to face the small square (IR window) on the
top, left-hand side of the DISH Network
remote, as shown on page 66. Both the DISH Network remote and the original
device’s remote control should remain on a flat,
stable surface for the duration of the learning
process.
6
On the DISH Network remote control,
press the button you want to teach. Your DISH Network remote control must learn
commands one button at a time.
7
On the original device remote control,
press and hold the button you want
learned.
• If the DISH Network remote learns
the command, the mode light
blinks off and then back on.
• If the mode light blinks three times
or remains lit, the DISH Network
remote did not learn the command.
You may need to try pressing the button on the
original device’s remote several times for the
DISH Network remote to learn the command.
8
After a button has learned a command suc-
cessfully, repeat step 6 and step 7 until all
commands you want have been learned. If the remote control times out while learning
commands, the mode light will go out, and then
you must start over with step 3.