Dish Network Duo ViP 222 - Manual (Page 81)

Remote Controls
73
Tips
T
IPS
• If using a specific channel for TV2 (for example, channel 60), TV2’s remote control
must be programmed with a TV2 channel/input before you can use RECOVER.
• Place the channel sticker on the remote TV and write down the channel you use to
watch DISH Network programming. The stickers are inside the front cover of this
guide.
• If you don’t want to accidentally change channels on your TV or VCR, try
programming the remote control in Limited Mode as described on page 62.
• Make sure you have a UHF remote-control antenna connected to the receiver’s back
panel input jack so you can use Remote Control 2. See page 15 for instructions.
Q
UESTIONS
• My remote doesn’t control my receiver or other components. What should I do?
– Put the remote control is in the correct device mode (page 62).
– Check the batteries in the remote control (page 15).
– Verify the remote control address (pages 59 and 65).
– Check the UHF remote-control antenna is installed (page 15).
– Adjust the position of the UHF antenna for improved reception (page 60).
• Why does my receiver change channels or display menus at random? Your
neighbor may have their remote control set on the same address. Change the
address on your remote control and receiver as described on page 58. If that doesn’t
help, then you may have to install a UHF 10dB attenuator as described on page 61.