Dish Network Duo ViP 222 - Manual (Page 76)

Chapter 9
68
Controlling Other Components
Controlling a Tuner/Amplifier
Use the following remote-control buttons to control a tuner or amplifier. When the remote
control is set up as described on pages 61 and 66, press the AUX mode button to set the
remote to AUX mode. The AUX mode button will stay lit for two seconds to show you’ve
set the remote to AUX mode. Make sure to keep the remote in AUX mode to use the
following buttons.
9
To complete the learning sequence:
• Press the mode button on the
DISH Network remote. This saves
all the commands for that mode,
and exits learning to return to
normal remote control operation.
• To cancel learning, do not press
any buttons on either remote
control for at least 30 seconds. The
DISH Network remote control
times out and returns to normal
operation.
Note: No learned commands are
saved if the DISH Network
remote control times out
before completion.
The learning sequence also ends if the remote:
• Runs out of memory for more
learned commands. It saves the
commands you have learned for
equipment in this mode, exits
learning and returns to normal
remote control operation. Then the
DISH Network remote cannot learn
additional commands.
• Batteries are too low for learning.
All the mode buttons will blink
quickly eight times. Learning ends,
in this case, with no learned
commands saved, and the DISH
Network remote returns to normal
operation. Change the batteries
(see instructions on page 15).
Power
Volume & Mute Buttons
Turns the
tuner/amplifier
on and off
Control tuner/amplifier
volume
To use the features described in this section, make sure
you are in AUX mode by pressing the AUX Mode button.
AUX
Press this
button for
AUX Mode
Select/Arrows
Button
Channel up/down
with the Arrow buttons.
Change tuner/amplifier
inputs with the Select
button