Dish Network Duo ViP 222 - Manual (Page 99)

Connections and Setup
91
Connecting to the Remote TVs (TV1 or TV2)
using these instructions for both TV1 and TV2, pick a different channel for each (for
example, Channel 60 for TV1 and Channel 64 for TV2).
6
Set all of your remote TV(s) to the channel mode (air or cable) taht you wrote in step 5.
7
Tune all of your remote TV(s) to the channel(s) you wrote in step 5. This is the channel
you will use to receive your satellite programming.
8
Connect CH 21-69 O UT on the receiver to your existing wall cable outlet using a coaxial
cable.
Note: If you do not have an existing in-home cabling system, then you will need to run
coaxial cable to each TV in other rooms. This type of installation can be difficult, so you
may want to contact a professional to perform this installation.
9
Place the yellow sticker on the CH 21-69 O UT cable near where the cable attaches to the
receiver. The stickers are located inside the front cover of this guide.
10
Turn on the nearby TV (the TV that gets programming from TV1 output).
11
Make sure that the receiver's green TV1 indicator is on.
12
Press MENU. Select System Setup, Installation, and then Modulator Setup.
13
With the Modulator Setup screen displayed on the nearby TV, use Remote Control 1 to do
the following:
a
Under TV2 Out (or TV1 Out), select either Air (air channel numbers) or Cable (for
cable channel numbers) based on what you wrote down in step 5.
b
Under TV2 Out (or TV1 Out), use the UP and DOWN ARROWS to change the
modulator channel to the one you wrote in step 5.
c
Select Done.
Note: For TV1 O
UT , if you locked the receiver, a message will display asking you to
enter your password.
14
For some TVs, you must run a channel scan so that the TVs will find and display the
selected channel from the receiver. Run the channel scan on all remote TV(s), if available.
See your TV user’s guide for instructions.
15
Confirm that you see a picture from the receiver on your remote TV(s).
• If your picture looks good, go to step 23.
• If your TVs do not have a picture or if it is not as clear as you would like it to be, go to
the next step.
16
You may need to change the cable connection on the splitter that sends the TV signal
throughout your house. The change that needs to be made is to reconnect the cable
coming from the receiver’s H
OME D ISTRIBUTION jack from the output of the splitter to the
input of the splitter using the following instructions:
TV1 Channel: Air/Cable TV2 Channel: