Dish Network Duo ViP 222 - Manual (Page 97)

Connections and Setup
89
Connecting to the Remote TVs (TV1 or TV2)
CH 3-4 Out
Use these instructions if you’d like to connect your receiver to an SD television.
1
Connect a coaxial cable from the CH 3-4 output on the receiver to the nearby TV’s tuner
input jack.
2
Place the white CH 3-4 sticker on the cable near where the cable connects to the receiver
(the stickers are inside the front cover of this guide).
3
Plug in the power cord for the receiver.
4
Turn on the receiver by pressing the front-panel POWER button and then make sure the
TV1 indicator is lit.
5
Turn on the nearby TV.
6
Tune the TV to channel 3. Confirm that you are seeing a picture from the receiver.
7
If you do not see video of the Point Dish screen, tune the TV to channel 4.
Note: If you want to change the channel that the CH 3-4 jack provides to your TV, see
Modulator Setup on page 76.
8
Place one of the channel stickers (3 or 4) near or on your TV. The stickers are located
inside the front cover of this guide.
C
ONNECTING TO THE
R
EMOTE
TV
S
(TV1
OR
TV2)
This section describes how to connect the receiver’s H OME D ISTRIBUTION output to the
cable-ready remote TV located in another room away from the receiver. You can use
these instructions to connect TVs in your house to see programming from TV1 or TV2.
This installation uses your in-home cable system. If your house does not have built-in
cabling, it will be necessary to run cables from the receiver to each remote TV. Due to the
difficulty of this installation, you should consider having this professionally installed. Call
DISH Network at 1-800-894-9131.
If you’re using TV1 in a room away from the receiver, be sure to order the replacement
remote control that uses UHF Pro signals instead of IR. Call your DISH Network retailer or
go to www.dishnetwork.com, select Shop, and then click on Accessories.