Applied Motion STM17C-3CE - Manual (Page 7)

Getting Started
The following items are needed:
a 12 - 48 volt DC power supply, see the section entitled “Choosing a Power Supply” for help in choosing one •
a small flat blade screwdriver for tightening the connectors (included) •
a PC running Microsoft Windows 98, 2000, NT, Me, XP, Vista, or Windows 7 •
the CD that was included with your STM17 •
a programming cable (included with RS-232 models) •
Installing Software
Before using the STM17 integrated motor and ST Configurator software in an application, the following steps are neces-
sary:
Install the ST Configurator software from the CD. •
Launch the software by clicking Start...Programs...Applied Motion Products. •
Connect the drive to the PC using the programming cable. When using RS-422/485, the drive must be set up in a •
4-Wire configuration (see “Connecting to a host using RS-422/485”.)
Connect the drive to the power supply. See instructions. •
Apply power to the drive. •
The software will recognize the drive and display the model and firmware version. At this point, it is ready for use. •
If you are using an STM17Q and plan to create a Q program to be stored in the drive, you will also need to install • Q
Programmer .
Mounting Hardware
As with any step motor, the STM17 must be mounted so as to provide maximum heat sinking and airflow. Keep enough
space around the unit to allow for airflow.
Never use the drive where there is no airflow or where other devices cause the sur-
rounding air to be more than 40°C (104°F).
Never put the drive where it can get wet.
Never use the drive where metal or other electrically conductive particles can infiltrate
the drive.
Always provide airflow around the STM17.
Additional Reading
To learn more about ST Configurator , please refer to the built-in help.
To learn more about the Q and SCL languages, please read the Host Command Reference , available on your CD and at
www.applied-motion.com.
7
STM17 Hardware Manual
920-0034 rev A
9/30/2010