Applied Motion TXM24Q-1AG - Manual (Page 20)

20
Rev. D
920-0087
TXM24 RS232/485 Hardware Manual
4 Troubleshooting
LED Error Codes
The TXM24 uses bi-colour LED to indicate status. When the motor is enabled, the green LED
flashes slowly. When the green LED is solid, the motor is disabled. Errors are indicated by
combinations of red and green flashes as shown below. This feature can be disabled for certain
warnings but not for alarms.
Code Error
Solid green no alarm,motor disabled
Flashing green no alarm,motor enabled
1 red,1 green motor stall
2
red,1 green ccw limit
2 red,2 green cw limit
3 red,1 green drive overheating
3 red,2 green internal voltage out of range
3 red,3 green blank Q segment
4 red,1 green power supply overvoltage or excess regen
4 red,2 green power supply undervoltage
4 red,3 green flash memory backup error
5 red,1 green over current/short circuit
6 red,1 green open motor winding
6 red,2 green bad encoder signal
7 red,1 green communication error
7 red,2 green flash memory error