Applied Motion SV7-Q-EE - Manual (Page 10)

6/26/2010
920‐0032a3 eSCL Communication Reference Manual Page 10
6. Next, enter the subnet mask as “255.255.255.0”.
7. Be sure to leave “Default gateway” blank. This will prevent your PC from looking for a router on this
subnet.
8. Because you are connected directly to the drive, anytime the drive is not powered on your PC will
annoy you with a small message bubble in the corner of your screen saying “The network cable is
unplugged.”
Option 3: Use Two Network Interface Cards (NICs)
PC NIC1 NIC2 LAN DRIVE
This technique allows you to keep your PC connected to your LAN, but keeps the drive off the LAN, preventing
possible IP conflicts or excessive traffic.
1. If you use a desktop PC and have a spare card slot, install a second NIC and connect it directly to the
drive using a CAT5 cable. You don’t need a special “crossover cable”; the drive will automatically
detect the direct connection and make the necessary physical layer changes.
2. If you use a laptop and only connect to your LAN using wireless networking, you can use the built‐in
RJ45 Ethernet connection as your second NIC.
3. Set the IP address on the drive to “10.10.10.10” by setting the rotary switch at “0”.
4. To set the IP address of the second NIC:
a. On Windows XP, right click on “My Network Places” and select properties.
b. On Windows 7, click Computer. Scroll down the left pane until you see “Network”. Right click and
select properties. Select “Change adapter settings”
5. You should see an icon for your newly instated NIC. Right click again and select properties.
a. Scroll down until you see “Internet Properties (TCP/IP)”. Select this item and click the Properties
button.
b. On Windows 7 and Vista, look for “(TCP/IPv4)”