AXING SKQ 2-01 - Manual (Page 10)

Programming
SKQ 2-01
© AXING AG – state of the art: July 2012 – Reserving change in design and type Page 10
4.5 Configuration
Select menu item “Configuration” and confirm
with OK.
Fig. 12 Configuration
The configuration menu is opened.
Fig. 13 Configuration menu
4.5.1 Audio language
Fig. 14 Audio language
With VOL / VOL preset languages are
selected (the broadcasting service must offer
these languages).
Confirm by pressing OK.
If ALL is selected instead of a language code,
all languages offered by the channel are
transmitted and the language can be selected
on the DVB-C receiver (recommended
setting).
4.5.2 LNB supply
The LNB supply can be switched off
Fig. 15 LNB supply
Press the VOL / VOL keys to select if you
want the LNB supply to be switched on or off.
normal = LNB supply on
no voltage = LNB supply off
• If a Quattro LNB is connected, at least one
LNB duct must be supplied with power, the
others can be switched off. (recommended
setting)
• If an input distributor is used, the left duct
of the first module on the front left side
always is responsible for the power supply
of the LNB connected to this input distribu-
tor. In this duct, the LNB supply must be
set to Normal. All the other SKQ 2-01 con-
nected to this input distributor must be set
to "No voltage" under LNB supply.
• With the multiswitch, all ducts must be set
to "Normal".
4.5.3 Start UP video output
Fig. 16 Start UP video output
Press the VOL / VOL keys to select how
to proceed after a voltage interruption.
Modulator Menu = basic setting
After a power break or if inside the menu no
other settings are done, the modulator menu is
shown on analogue output.
For error free displaying of high definition
programs the setting modulator menu should
be used.
High definition programs can not be shown via
analogue output.
MPEG22 SD monitor
Using this setting the SD-program is shown via
analogue output, which has been confirmed in
channel list by pressing the OK button.
4.5.4 TSId output:
This function is predominantly used with CA
modules or in the DVB-T mode.
If the available PIDs of the CA module or the
available output data rate in the DVB-T mode
are exceeded, the channels of a transponder
must be divided. During the search, some
receivers skip channels with duplicated TSIds.
A new TSId can be manually assigned to the
divided programs by means of the TSId output
function. As-delivered, the TSId output is set to
Auto, i.e., the receiving transponder passes on
the TSId 1 to 1.
!
!
!