AXING SKQ 2-01 - Manual (Page 12)

Programming
SKQ 2-01
© AXING AG – state of the art: July 2012 – Reserving change in design and type Page 12
Select the program by pressing OK.
The screen display goes back to the submenu
Scan Transponder run.
The transponder data is applied automatically
from the list.
Change to Scan by pressing CH .
Start the scan by pressing OK.
It will take a few seconds.
After "Please wait", "Scan transponder" and
"Transponder data found" appears "User
settings saved" and the channel list is opened.
Fig. 20 Display scan transponder
4.5.6 Dynamic SI
This function is only relevant for Austria. This
function is used to switch the ORF regional
switchover on or off.
Select menu item "Dynamic SI" and press OK
to confirm.
To activate the function, press the VOL /
VOL keys.
4.6 Channel list
After „Scan Transponder“ the channel list is
displayed. This can also be selected in the main
menu.
All programs found on the transponder are
displayed.
Fig. 21 Channel list
Behind the program names appears (FTA) for
free to air programs and (CA) for scrambled
ones and at the end of each line at first a minus
+.
Press the SYS key to change between –, + and
$.
• Programs marked + will be transmitted.
• Programs marked – won´t be transmitted.
• CA programs, which should be encoded in
the headend, need to be signed with a $ .
Important: Press OK if the programs to be
transmitted are selected. The cursor must be
positioned on a program marked with + or
$.
The program on which the cursor is set, will be
transmitted to analogue output (RCA socket).
This happens only in case that configuration -
video start up - MPEG2 SD monitor is selected.
After approx. 5 seconds appears "reading
services, please wait" on the display.
Wait until the display disappears.
LCN (logical channel numbering)
In channel list, programs are numbered
continously.
This numbers can be edited by the help of the
keys in number field of the remote control.
With it a new mapping of programs can be
done. The end device must support the LCN-
function. For example "BBC" program place
LC01, "CNN" program place LC02.
Up to 99 program places can be allocated
overlapping the units.
If the allocation shell be deleted, the 0 on the
key field of remote control has to be pressed
twice. It must be confirmed by the OK button.
Change to the main menu and then to the
"Modulator" menu by pressing the menu key.
It is also possible to transmit all programs of a
transponder depending on the setting in the
"Modulator menu" in the item "DVB-C
constellation". The option to transmit a
complete transponder depends on the data
rate, the number and the modulation depth of
the individual programs (see 4.7 Modulator on
page 13.).
!