AXING SKQ 2-01 - Manual (Page 14)

Programming
SKQ 2-01
© AXING AG – state of the art: July 2012 – Reserving change in design and type Page 14
Next to the channel number is displayed the
center frequency in brackets.
Change the center frequency if necessary by
up to 4 MHz in steps of 1 MHz upwards or
downwards.
4.7.6 Exit modulator menu
Press the EXIT key. The menu is closed and all
settings are saved.
4.8 CI module recognized
Before installing or deinstalling a CA modu-
le, disconnect the power supply!
Fig. 25 CI Menu
If a CA module is plugged in the duct, the "CI
Menu" submenu appears in the main menu.
Select the menu item “CI Menu” and confirm
with OK.
According to used CAM different settings can
be done.
It's also possible to make an enquiry about
smart card information.
The effects of the single settings in sub menus
are described from manufacturer of the CAM.
A module for 4 programs is able to decode 1 to
4 programs; if you try to decode a further
program, the SKQ 2-01 produces a
malfunction!
The permission to decode encoded programs
in the head ends must be given by the
respective program provider.
4.9 Exit the configuration
Fig. 26 Exit the configuration
Select the menu item “Exit” and confirm with
OK.
After selecting the menu item “Exit”, the
programming is ended. All settings are saved.
The programming selection switch must be set
to center position.
4.10 Other functions
Additional settings can be made without
starting the main menu.
Following described settings can only be done,
if all menus are closed.
Setting the audio level
The audio level on the A/V output can be
adjusted using the VOL / VOL keys.
Fig. 27 Setting the audio level
Change program
The program list is loaded by means of the
“EPG” key.
Fig. 28 Channel list
The desired program can be selected from the
list by means of the CH /CH keys.
Press the “OK” key to apply the program.
Additional program information can be loaded
by means of the “INFO” key.
Display input signal quality
After pressing the “F1” key, the quality of the
input signal is displayed.
Fig. 29 Quality of the input signal
The display is closed by pressing “EXIT”.
!
!
!
!
!