Delta Electronics Elevator Drive VFD-VL - Manual (Page 106)

Chapter 4 Parameters|
Revision Nov. 2008, VLE1, SW V1.03 4-51
Group 3 Analog Input/Output Parameters
03-00 Analog Input 1 (AUI1)
Factory Setting: 1
03-01
Analog Input 2 (ACI)
Factory Setting: 0
03-02 Analog Input 3 (AUI2)
Factory Setting: 0
Control Mode
Settings
VF VFPG SVC FOCPG TQCPG FOCPM
0: No function ○ ○ ○ ○ ○ ○
1: Frequency command (torque limit under TQR control mode) ○ ○ ○ ○ ○ ○
2: Torque command (torque limit under speed mode) ○
3: Torque compensation command ○ ○ ○ ○ ○ ○
4-5: Reserved
6: P.T.C. thermistor input value ○ ○ ○ ○ ○ ○
7: Positive torque limit ○ ○
8: Negative torque limit ○ ○
9: Regenerative torque limit ○ ○
10: Positive/negative torque limit ○ ○
11: Preload Input ○
When it is frequency command or TQR speed limit, the corresponding value for 0~±
10V/4~20mA is 0 – max. output frequency(Pr.01-00)
When it is torque command or torque limit, the corresponding value for 0~±10V/4~20mA is 0 –
max. output torque (Pr.07-14).
When it is torque compensation, the corresponding value for 0~±10V/4~20mA is 0 – rated
torque.