Drylam Fujipla PLS3311 - Manual (Page 52)

AL-MEISTER PLS3311 INSTRUCTION MANUAL <Rev.3>
7．TROUBLE SHOOTING
PROBLEM CHECK IF SOLUTION PAGE
● CUTTING ERROR Cutting blade is not working properly. ・Close the cutter cover.
・ Press [RESET] key to put
the cutting blade back into
the starting position.
43
・ CAUTION: Do not touch
the cutter unit.
Paper is jammed inside the machine.
・ Close the cutter cover.
・ By using the manual
feed switch, remove the
jammed paper. ・Press
[RESET] key.
14
・ CAUTION Be careful that
your fingers or
clothes do not get caught
in the rollers.
・ Turn the pull roller lever
upward. Adjust the de-
curling lever to decrease
the curling.
Laminated upward paper curls 47
The margin of the paper and film is
less than 0.16”. ・ Adjust the paper
position in the feeder tray.
・
The film must always be
smaller than the paper by
0.16” at both sides.
49
The starting point of the cutting blade
is not correct. Paper is cut irregularly. ・ Change the value of cut
timing. ・The cutting must
be done on the straight
portion of the blade, not
the V-shaped portion of
37