Drylam Fujipla PLS3311 - Manual (Page 54)

AL-MEISTER PLS3311 INSTRUCTION MANUAL <Rev.3>
・ Press [RESET] key. 50
PROBLEM CHECK IF SOLUTION PAGE
● FEEDING ERROR Paper is stuck between the
feeder section and the
lamination section. ・ Open the feeder cover.
・ Remove all the jammed
paper.
・ Press [RESET] key.
CAUTION ・Laminating rollers
get hot. Be careful not to get
burned.
11
● DISCHARGE ERROR Laminated paper is stuck in
the lamination section and/or
the cutter section. ・ Open the feeder cover and
the cutter cover. ・Remove
the jammed paper by using
the manual feed switch.
・ Press [RESET] key.
・ CAUTION Laminating
rollers get hot. Be careful not
to get burned.
11
14
・ Be careful that your fingers
or clothes do not get caught in
the rollers.
Heating roller lever or Pull
roller lever is in UP position. ・ Turn the pull roller lever
and heating roller lever to
DOWN position. ・Press
[RESET] key.
23