Drylam Fujipla PLS3311 User Manual
Page 57
AL-MEISTER PLS3311 INSTRUCTION MANUAL <Rev.3>
49
● [NOT READY] appears
on the display and cannot
clear.
After solving problems, [NOT
READY] appears.
・
Remove paper in the
machine. Set film again.
-
● More than two sheets
are transported at one
time.
Each sheet of paper is too
tightly stacked.
・
Hold the stack of paper
vertically and tamp it down
and fan the paper well. Even it
up.
47
Paper is curling.
・
De-curl paper.
・
Adjust the feeding
pressure.
-
PROBLEM
CHECK IF
SOLUTION
PAGE
● Paper in the feeder tray
is not picked up.
Due to paper not being pulled
by the feeding roller.
・
Open the feeder cover and
inspect for any debris. Also,
clean the rollers.
11
Due to too much resistance by
the paper pressure lever
・
Lower the paper pressure
lever
Paper is curling.
・
Be certain paper lies flat
before placing it on the
Feeder Tray.
-