Future Automation PLS - Manual (Page 8)

In
st
al
la
ti
o
n
:
S
ta
ge
3
Page 7 of 22 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
PLS - Plasma Lift and Swivel
Fixing the Lift in the Cabinet
Place the mechanism within the cabinet.
Raise the beam to the top and carfully guide
the base through the opening in the top.
Place the mechanism within the cabinet.
Raise the beam to the top and guide base
through the opening in the top. IR remote
STOP button will stop the lift.
With the base properly located, use the 8
pointed screws supplied, 4 on each side,
to pin the mechanism in place, fixing its
position left and right. These 8 screws
should be screwed through the middle
hole of each of the clusters of 3, shown
below right.
With the lift fixed in position, use 8 wood
screws on each side to secure the lift to
the cabinet.