ILUMINARC Ilumiline™ Inground Tri-12 IP - Manual (Page 12)

Installation
8 Ilumiline Inground IP Optic 25 Series User Manual Rev. 10
Always connect
the Ilumiline
Inground IP
products to a protected
circuit with an appropriate
electrical ground to avoid
the risk of electrocution or
fire.
Never connect
the Ilumiline
Inground IP
products to a rheostat
(variable resistor) or
dimmer circuit, even if the
rheostat or dimmer
channel serves only as a
0 to 100% switch.
Make sure to
connect the
Ilumiline
Inground IP products to a
power line with the proper
voltage and frequency, as
per the specifications in
this manual or on the
product’s sticker.
The listed
current rating
indicates the
maximum current draw
during normal operation.
If you choose to
bury the power or
signal distribution
boxes, make sure that
they are IP67 rated or
greater.
Please refer to all
applicable local
codes and
regulations for the proper
installation of this product.
AC Power
The Ilumiline Inground IP products have an auto-ranging power supply that works with an
input voltage range of 100~240 VAC, 50/60 Hz.
Make sure you are connecting this product to the proper voltage, as per the specifications in this
manual or on the product’s sticker.
Power Consumption
To determine the power requirements for the Ilumiline Inground IP products, see the
label affixed to the side of the product. Alternatively, you may refer to the
specifications chart in the
Technical Information chapter of this manual.
The listed current rating indicates the maximum current draw during normal operation.
AC Plug
Both Ilumiline Inground IP products come with a bare-ended power input cord for
hardwire installation. Use the table and the illustration below to wire a plug.
Connection Wire (US) Screw Color (US) Wire (Europe) IP67 Pin
AC Live Black Yellow or Brass Brown 1
AC Neutral White Silver or Gray Blue 2
AC Ground Green/Yellow Green Green/Yellow 3
Power Wiring
To provide power, you have two options:
· Connect the bare-ended IP67 rated AC power cable from the product to an IP67
rated power connector.
· Use an IP67 rated junction box. If so, make sure to use IP 67 rated conduit for
surface installations.