ILUMINARC Ilumiline™ Inground Tri-12 IP - Manual (Page 16)

Installation
12 Ilumiline Inground IP Optic 25 Series User Manual Rev. 10
Refer to the
Operation chapter
to learn how to
enable the
Ilumiline Inground Tri 12 IP
Optic 25 RGB to operate
with the ILUMICON
controller.
To assign
individual DMX
addresses to each
product, you must
connect the Ilumicode to
each product, individually.
ILUMINARC®
suggests that you
connect no more
than 20 products
in this mode and keep the
total distance to less than
60 m (197 ft). Otherwise,
you might need to use an
optically isolated signal
amplifier.
ILUMICON
Only the Ilumiline Inground Tri-12 IP Optic 25 RGB will work with the ILUMICON
controller You can use the ILUMICON instead of a standard DMX controller. Please refer
to the ILUMICON User Manual to learn how to use this controller with the Ilumiline
Inground Tri 12 IP Optic 25 RGB.
The following figure illustrates how to connect the ILUMICON controller to the Ilumiline
Inground Tri 12 IP Optic 25 RGB.
Ilumicode
Both Ilumiline Inground IP products use the Ilumicode Addresser for configuration
purposes. The following diagram shows how to connect the Ilumicode to either product.
This connection will control multiple products at the same time. In addition, all connected
products will be assigned to the same DMX address.
Important: The Ilumicode must be used to configure this product. The Ilumicode
can be purchased separately through your Iluminarc sales representative.