Junger Audio D*AP4 FLX / D*AP4 LM Edition - Manual (Page 78)

D*AP4
73
Technical Data – Option Board AES/EBU I/O [O_DAP_AES_a]
Standards Relevant specifications comply with AES3-X-2009, IEC 60985 and
AES11-2009
Audio 24 bits, transparent forwarding of PCM and compressed audio (w/o SRC)
24 bits, PCM, sample rate converter (SRC) activated
Audio Sample Rate 44.1, 48, 88.2, 96 kHz, (32 … 196 kHz @ inputs with SRC)
8 channels (4 stereo inputs)
Connector type D-Sub25 connector female, same for outputs
Impedance 110 Ohm or 75 Ohm, jumper selectable
(110 Ohm default)
Input level 0.3 … 5 Vpp @ 110 Ohm differential
0.3 … 5 Vpp @ 75 Ohm single-ended
Inputs
Sample Rate
Converter (SRC) THD+N -120 dB @ 0 dBFS, 1 kHz
Latency < 0.3 ms
8 channels (4 stereo outputs)
Connector type D-Sub25 connector female, same for inputs
Impedance 110 Ohm or 75 Ohm, jumper selectable
(110 Ohm default)
Outputs
Output voltage 3 Vpp (typ.) @ 110 Ohm differential
1 Vpp (typ.) @ 75 Ohm single-ended
General Features •
Power fail relay bypass (can be deactivated by jumper)
•
Input sample rate converters (SRC)
•
Electrical isolation between inputs, outputs and device (if
configured for differential mode, 110 Ohm)
•
AES3 channel status management, non-audio detection
•
Master-sync capable
Technical Data – Option Board MADI I/O, BNC [O_DAP_MB_a]
Standards Relevant specifications comply with AES10-2008 and AES11-2009.
Audio 24 bits, transparent forwarding of PCM and compressed audio
Audio Sample Rate 44.1, 48, 88.2, 96 kHz, (88.2, 96 kHz short framing)
64/56 channels @ 44.1 and 48 kHz, 32/28 @ 88.2 and 96 kHz
Processable by D*AP8: 16 channels @ 44.1, 48 kHz
Processable by D*AP4: 8 channels @ 44.1, 48, 88.2, 96 kHz
Impedance 75 Ohm
Input level 0.15 … 0.8 Vpp @ 75 Ohm
BNC Input
Cable length (max.) 150 m (Belden 1694A)
64/56 channels @ 44.1 and 48 kHz, 32/28 @ 88.2 and 96 kHz
Processable by D*AP8: 16 channels @ 44.1, 48 kHz
Processable by D*AP4: 8 channels @ 44.1, 48, 88.2, 96 kHz BNC Output
Impedance 75 Ohm