Junger Audio b42 - Dynamics Processor - Manual (Page 15)

3. INSTALLATION
Operation manual b42, chapter 3 -installation- page 3-1
INSTALLATION
The digital dynamics processor b42 was carefully packed in the
factory and the packaging was designed to protect the
equipment from rough handling. Please examine carefully the
packaging and its contents for any signs of physical damage,
which may have occured in transit.
The digital dynamics processor b42 is a device under the safety
category Schutzklasse 1 in keeping with the VDE 0804
standards and may only used with power supply installations
built according to regulations.
Check the voltage details printed at the rear panel are the same
as your local mains electricity supply.
The dynamics processor b42 is equipped with standard
connectors (see also chapter 3).
Before connecting the digital dynamics processor b42 switch the
power off at all connected units.
The digital dynamics processor b42 is made as standard 19“ unit
(EIA format). It occupies 1 RU (44 mm height) space in a rack.
Please allow at least additional 3“ depth for the connectors on
the rear panel.
When installing the unit in a 19“ rack the rear side of the unit
needs some support, especially for mounting in flight cases.
The digital dynamics processor b42 should not be installed near
units which produce strong magnetic fields or extreme heat. Do
not install the filter processor directly above or below power
amplifiers.
If, during operation, the sound is interrupted or displays no longer
illuminate, or if abnormal odor or smoke is detected immediately
disconnect the power cord plug and contact your dealer or
Jünger Audio.
3.1
UNPACK THE UNIT
3.2
POWER SUPPLY
3.3
CONNECTIONS
3.4
RACK MOUNTING
3.5
OPERATION
SAFETY
3