Junger Audio D*AP LM2 / D*AP LM4 - Digital Audio Processor - Manual (Page 18)

14
D*AP LM 4
Web GUI – SYSTEM – Software Update
Software Update - The files to update the LM 4 will be available in ZIP format. You must unpack it to your
PC in order to access them for the update procedure.
You will find an image file for the LM 4 core system in the format: "rel_lm4_x_y_z.img"
as well as update files for components, like the optional interface boards
in the format: "rsdi150_v47.sdi".
To update the LM 4, you must <Browse …> for the respective
Firmware File(which you have unzipped before) and press .
After finishing the procedure the device will reboot.
You may also update the firmware of an SDI board installed in one of the
two interface slots (or both). The example above shows one SDI I-O board installed into
interface 1 slot. You must select the appropriate file from the firmware update bundle (ZIP file)
and press
afterwards.
The LM 4 has a few options you may buy extra. Which option is active on your device you can read from
the licensing display in the bottom right part of this page. If you buy a license later on you must save the
"license info" file and send it to your dealer. After purchasing the option you will get a "license" file in return
which you must apply from there. After rebooting the device the license becomes active.
Web GUI – SYSTEM – Reboot
Reboot – Following changes to the set up or configuration, a reboot may be required. Two additional
options allow for restoring the factory default settings and overwriting the current network IP settings if they
have been changed.