Junger Audio D*AP LM2 / D*AP LM4 - Digital Audio Processor - Manual (Page 20)

16
D*AP LM 4
Web GUI – INTERFACE – AES I/O
AES I/O – Allows the set up of AES input source selection along with a display of signal input status.
Input Status
each AES input has a status detection that may show :
PCM or Fail (no carrier, unlock, cranky [too much jitter]).
If one of the inputs is not assigned by the ROUTING section, its
status will not be incorporated into the System Status.
Input Sample Rate Converter for asynchronous sources it is possible to turn a SRC on per input. If
a SRC is turned on and the input status becomes Non-PCM, the
respective SCR will be turned off automatically in order to maintain
the original data structure of an encoded bit stream like Dolby E.
AES Relay Bypass the power fail bypass relays of all 2 I/Os may be activated manually.
Output Channel Status the channel status can be either
transparent from the input source
of the LM 4 or may be overwritten.
The pull down offers these options :