Junger Audio d02 - Digital Dynamics Processor - Manual (Page 20)

3. CONTROL AND DISPLAY ELEMENTS
3-4
The limiter limits the maximum output signal level of the d02 precisely to
the set digital reference level. (see also 2.4., and, for details of setting the
digital reference level, see under "display"). The limiter should be always
active to ensure that output level of the d02 never exceeds the preset
digital reference level.
The LED shows a red warning signal when the limiter is turned off.
The limiter works with a look ahead time (signal delay) of approx. 2 ms.This
delay time is present even when the limiter is turned off.
Two different reference levels can be set, one reference level for use when
using a digital input signal, and another for use when using analogue input.
In the bypass mode (corresponding LED lits red) the digital signal is passing
unprocessed through the DSP to the output. The signal delay time of approx.
2 ms is also effective in bypass mode.
The bypass function is not a relay bypass and is therefore not effective when
the device is turned off from mains power.
limiter
bypass