One Systems PT-10 User Manual
Page 22
One Systems, Inc. 6204 Gardendale Dr., Nashville, TN 37215
22
The PT-30 showing ALL three band locations used
Mount the PT-30 bracket assembly to the pole at the desired height on the pole. The
bracket is mounted to the pole using BAND-IT stainless steel bands. DO NOT
SUSTITUTE bands of other material or other widths! There are 3 locations for the PT-30
and ALL 3 slots MUST BE USED.
It is REQUIRED that ALL bands be DOUBLE wrapped (Two independent bands per
slot!). Double wrapping will insure a strong and secure mounting of the bracket to the
pole. The selection of stainless steel banding materials is based on the intended
application. The 304 grade bands and buckles should be used when the 304 grade PT-
30 is used. The bands should be sourced from BAND-IT ONLY and should be as
follows:
BAND-IT # C206R9 stainless steel bands
BAND-IT # C25699 buckles
BAND-IT # C00169 tensioning tool
The stainless steel band is Type 201SS 0.030 inches (0.762mm) thick and 0.750 inches
(19mm) wide.
IF the “Marine grade” 316 stainless steel version of the PT-30 is used then the bands
are as follows.
BAND-IT # C406R9 stainless steel bands (316 stainless steel)
BAND-IT # C45699 buckles (316 stainless steel)
BAND-IT # C00169 tensioning tool
The stainless steel band is 316 grade 0.030 inches thick by 0.750 inches wide