Paxton Superchargers Carbureted Mustang Novi 2000 - Manual (Page 21)

3-5
P/N: 4PFX020-020
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
24APR06 v1.1 MusGT(4PFX..020 v1.1)
Q. Use an 18mm wrench to rotate the accessory
belt tensioner and reinstall the factory belt.
(See Appendix 1016710.)
R. Install the supercharger drive belt between
the crank pulley and the supercharger pulley.
Route the belt inside the idlers. Use a 3/8"
socket and extension and tighten the belt.
Once the belt is tensioned, tighten the nut on
the end of the adjustable idler so that it will
not back off.
S. Find the rubber air injection hose from the
diverter valve removed in an earlier step.
Shorten the hose by cutting 3" out of the
middle of the hose and 1-1/2" off the back
of the hose. Reconnect the two formed
pieces together with the sleeve and clamps
provided. Re-install the short end hose
between the diverter valve and fitting on the
side of the smog pump. (See Fig. 3-l.)
U. Trim the fan shroud as seen in Fig. 3-n. This
is easiest with a pneumatic cut-off wheel.
*** NOTE ***
Only the bottom and passenger sides are trimmed.
V. Install the supplied water pump pulley studs
into the w/Pump flange. Slide the two sup-
plied spacers stacked onto the studs. Re-
install the fan shroud and fan assembly into
the engine compartment. Attach the fan
assembly to the water pump. Using the sup-
plied washers and nuts to secure it, tighten
to factory specifications. Use the factory
screws to re-install the shroud onto the radi-
ator core support.
W. Locate the supplied radiator overflow bottle.
Using it as a template, mark the two hole
locations on the passenger’s side inner fend-
er. Drill a 1/8" pilot hole for each location.
Using the supplied self-tapping screws,
secure the overflow bottle in place. Route
the supplied 5/16" x 5' rubber hose from the
radiator fill port to the bottom of the over-
flow bottle. Refill the cooling system with
coolant previously drained. (See Fig. 3-o.)
Fig. 3-n
Fig. 3-l
Fig. 3-m
Fig. 3-o
2"
2"
3"
3"
T. Cut the upper radiator hose. Re-install the
longer piece on the thermostat housing
angled forward. Install the shorter 90º
degree piece on the radiator angled to the
side. Install the stainless tube between the
two pieces of hose and secure with the sup-
plied clamps. (See Fig. 3-m.)
PREFORMED
PIECES
PASSENGER’S
SIDE OF SHROUD