Paxton Superchargers Carbureted Mustang Novi 2000 - Manual (Page 27)

5-3
P/N: 4PFX020-020
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
24APR06 v1.1 MusGT(4PFX..020 v1.1)
Fig. 5-g
5.2 THROTTLE CABLE INSTALLATION
A. Using a small square file, file two grooves
in the firewall where the throttle cable goes
through. Reference the cable housing for
dimensions.
*** NOTE ***
The grooves should be in the 12 and 6 o:clock posi-
tions.
B. Install the cable in the firewall and connect
to the stock accelerator pedal.
C. Mount the throttle cable bracket to the car-
buretor enclosure using the supplied hard-
ware. (See Fig. 5-g.)
D. Secure the throttle cable to the mounting
bracket.
E. Install the throttle return-spring bracket to
the linkage arm using one 10-32 x 1/2" but-
ton-head screw. (See Fig. 5-f.)
F. Connect the cable to the linkage arm using
the Vortech retainer and washer. The retainer
should go through the cable end, washer,
return-spring bracket and into the arm.
*** NOTE ***
There is a plastic sheath that nomally protects the
cable. Remove this as it may hang-up on the end of
the cable housing.
G. Install the throttle return spring.
WASHER
THROTTLE
CABLE
10-32
BUTTON HEAD
VORTECH RETAINER
H. Check for full throttle by pressing the accel-
erator to the floor and verifying that the car-
buretor butterflies open fully.
I. If possible, pressurize the fuel system and
check for leaks.
J. Using the supplied 5/16" cap screws, install
the top cover on the enclosure and tighten
the screws.
K . Use the supplied hardware to plug any open
holes in the carburetor enclosure and cover.