Paxton Superchargers Ford Mustang GT - Manual (Page 19)

6-1
P/N: 4809628
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
05JUN03 v2.1 MusGT(4809628 v2.1)
Section 6
INTAKE TRACT MODIFICATIONS
6.1 INTAKE TRACT MODIFICATIONS
A. Install the discharge tube assembly as
shown, using the supplied rubber sleeves
and stainless steel clamps. (See Fig. 6-a.)
Fig. 6-a
B. Install the supplied length of rubber hose to
the end of the hard crank case ventilation
line that runs from the driver’s side valve
cover across the engine, (see Fig 6-b). Route
the hose over the passenger side valve cover
and towards the front of the engine.
Fig. 6-b
C. Install the idle air control valve to the throt-
tle body housing with the original hose, and
to the discharge tube with the supplied
length of rubber hose and hose clamps. (See
Fig 6-c.)
Fig. 6-c
D. The supercharger bypass valve requires a
vacuum source. Remove the existing plastic
coupler in the vacuum hose that runs along
the firewall on the passenger side. Replace
with the supplied vacuum ‘T’.( See Fig 6-d.)
Attach the supplied length of vacuum hose,
and route along the passenger side frame rail
towards the supercharger. It will be connect-
ed to the bypass valve assembly in a later
step.
Fig. 6-d