Pinnacle Systems NSD - Manual (Page 7)

3
Specifi cations
NSD Safety Mat System
2
NSD-TR-01
Controller
(Metal Box)
NSD-DR-01
Controller
(Basic DIN-rail)
NSD-DR-04
Controller
(DIN-rail with Diagnostics)
Enclosure: NEMA 12, 13, IP 54 NEMA 1, IP 32 NEMA 1, IP 32
Input Power: 120VAC +/- 10% @ 3 watts
50-60 Hz fused 24VDC +/- 20% @ 7 watts 24VDC +/- 20% @ 7 watts
Category/Type: 4 4 4
Relay Style: Monitored force-guided captive
contact safety relays Monitored force-guided captive
contact safety relays Monitored force-guided captive
contact safety relays
Relay Configuration: 2 N.O. Safety Relays (closed
when circuit activated)
1 Aux Output N.O. or N.C 2 N.O. Safety Relays (closed
when circuit activated)
1 Aux Output N.O. or N.C 2 N.O. Safety Relays (closed
when circuit activated)
1 Aux Output N.O. or N.C.
1 Fault Relay N.O.
Safety Relay Rating: 4A @ 220VAC 4A @ 220VAC 4A @ 220VAC
Reset Provisions: Manual or Automatic Manual or Automatic Manual or Automatic
Controller Response
Time: 15 msec. 15 msec. 19 msec per mat input used
Self-Checking
Intervals: Every 20 msec. Every 20 msec. Every 20 msec.
Number of Isolated
Zones: 1 to 13 (customer specified) 1 per controller 1 per controller
Maximum Number of
Mats: 20 20 4 with homerun wiring
20 with daisy chain wiring
External Reset
Provision: Green push button Green push button Green push button
Indicators:
Internal (on board): Yellow LED = +5VDC power
supply
Red LED = Normally dim,
brighter when mat is stepped
on. Cut wire detected when
not lit.
Green LED = Relay contact
detected closed when it should
have been open when not lit.
Must reset power to clear. Green LED(s) = next to
each relay (3)
Red LED = +12V
Yellow LED = +5V
Green LED = -5V Red LED = +12VDC
Green LED = +20VDC
Yellow LED = +5VDC
Green LEDs = one for each
relay (4 total)
External: Red LED = 1 or both relays are
de-energized.
Green LED = All relays are
energized. Red LED = 1 or both relays are
de-energized.
Green LED = All relays are
energized.
Yellow LEDs = 2 to show on/off
mat.
Yellow LED = relay fault if it
turns off. Red LED = 1 or both relays are
de-energized.
Green LED = All relays are
energized.
Yellow LEDs = 1 for each mat
status — (4 total)
Diagnostic Message
Display: N/A N/A Built-in
DeviceNet: N/A N/A Add suffix DN to Model #. See
next page for additional
information.
Warranty: 2 years 2 years 2 years