TVLogic LEM-250C - Manual (Page 29)

FHD OLED Reference Monitor 29
LEM-250C SDI A
●
USER CONFIG SET
- Used to save and apply three kinds of user
configuration.
- Available modes are USER1, USER2 and
USER3.
- Assignable items for each USER1, USER2 and
USER3 settings are the [MARKER] menu of
MARKER, CENTER MARKER, SAFETY AREA,
MARKER MAT and MARKER COLOR, the
[PICTURE] menu of BRIGHT, CONTRAST,
CHROMA, PHASE and APERTURE.
●
LOCK NUMBER
- Lock number is product’s serial number.
●
OSD DISPLAY
- Controls the OSD display time.
- Available values are 3 SEC, 20 SEC and
CONTINUE.
●
OSD POSITION
- Controls the OSD position.
- Available positions are Center, Right-
Top(T-R), Bottom-Right(R-B), Top-Left(L-T)
and Bottom-Left(L-B).
●
INTERNAL PATTERN
- This item generates internal white pattern.
- The white level select between 0% and 100%
(Per 5% increase or decrease)
●
SET DEFAULT
- User can use SET DEFAULT menu to initialize
to factory setting.
- Initializes the values to 0 of BRIGHT,
CONTRAST, CHROMA, PHASE and APERTURE
of the monitor.
●
KEY LED
- This item controls KEY LED ON/OFF.
- If the button with LED is pressed with the
KEY LED Off, LED comes on but goes off after
5 seconds later.
●
KEY LOCK
- This item locks all buttons on the front
panel except power, input select, and menu
buttons.
●
FAN CONTROL
- This item toggles Fan Operation Control ON/OFF.
●
IMAGE STICK MIN. (MIN)
- This item minimizes the image sticking by
reducing the screen brightness by 50% when
the video is stopped based on this set value
(in minutes).
- Value Range: Steps of 5 minutes increment
from OFF ~ 30 minutes.
[9] SYSTEM
5. Menu Operations
PAGE I >> PAGE II
USER CONFIG SET
LOCK NUMBER
LOCK ENABLE
OSD DISPLAY
OSD POSITION
INTERNAL PATTERN
SET DEFAULT
USER 1
LEM000000
--------
CONTINUE
L-T
OFF
PAGE II >> PAGE III
KEY LED
KEY LOCK
FAN CONTROL
IMAGE STICK MIN. (MIN)
ON
DISABLE
ON
OFF
LEM-250C SDI A
[9] SYSTEM