TVLogic LEM-250C - Manual (Page 31)

FHD OLED Reference Monitor 31
[9] SYSTEM
5. Menu Operations
●
DEVICE
-Used to select the device for color calibration.
●
COLOR CALIBRATION
- Connect the COLOR PROBE(e.g. K-10) to the
USB port to calibrate the monitor without a
PC.
* Refer to the section “Firmware Upgrade &
Color Calibration” for more information.
●
TARGET LUMINANCE
- Used to set the luminance.
●
K-10 CHANNEL
- Used to select the channel of COLOR
PROBE(K-10)
●
COLORSPACE
- Used to select the color space which will be
calibrated.
●
CALIBRATION START
- Used to start the calibration.
- Set the Color Calibration as [On]. The Color
calibration start menu will activate after
the USB connection is completed.
●
MEASUREMENT START
- Used to start the measurement.
- Set the Color Calibration as [On]. The Color
calibration start menu will activate after
the probe connection is completed.
●
COPY DATA
- Used to copy the files related to the
calibration.
●
CAL. LOG COPY START
- Used to save the CALIBRATION LOG file on a
USB drive.
* Set the COPY DATA as [On]. Activates only
when the USB drive(Thumb drive) is
connected.
●
S/W UPGRADE
- Used to upgrade the firmware using the USB
(Thumb drive).
* See section “Firmware Upgrade & Color
Calibration” for more information.
●
S/W UPGRADE START
- Used to start S/W upgrade. If the USB drive
is detected, the firmware upgrade becomes
activated.
PAGE IV >> PAGE V
DEVICE
COLOR CALIBRATION
TARGET LUMINANCE
K-10 CHANNEL
COLORSPACE
CALIBRATION START
MEASUREMENT START
Y:000.00 x:0.000 y:0.000
PAGE V >> PAGE VI
COPY DATA
CAL. LOG COPY START
S/W UPGRADE
S/W UPGRADE START
K-10
OFF
80 cd/m2
00:
REC-709
OFF
OFF
LEM-250C LEM-250C SDI A SDI A