Zilog ZUSBOPTS - Manual (Page 63)

UM017105-0511 Menu Bar
Zilog Developer Studio II – ZNEO™
User Manual
35
10. Select whether your project is linked to the standard C start-up module, C run-time
library, and floating-point library; select a small or large memory model (see the
Memory Models section on page 161); and click Next . For executable projects, the
Target and Debug Tool Selection step of the New Project Wizard dialog box is dis-
played; see Figure 36.
11. Select the Use Page Erase Before Flashing checkbox to configure the internal Flash
memory of the target hardware to be page-erased. If this checkbox is not selected, the
internal Flash is configured to be mass-erased.
12. Select the appropriate target from the Target list box.
13. Click Setup in the Target area. Refer to the Setup section on page 76 for details on
configuring a target.
14. Click Add to create a new target (see Add on page 78) or click Copy to copy an exist-
ing target (see Copy on page 79).
15. Select the appropriate debug tool and (if you have not selected the Simulator) click
Setup in the Debug Tool area. Refer to the Debug Tool section on page 80 for details
about the available debug tools and how to configure them.
16. Click Next . The Target Memory Configuration step of the New Project Wizard dia-
log box is displayed; see Figure 37.
Figure 36. New Project Wizard Dialog Box—Target and Debug Tool Selection