Zilog Z8F0130 - Manual (Page 145)

UM013037-1212 Debug Menu
Zilog Developer Studio II – Z8 Encore!
User Manual
121
3. Select the configuration with the appropriate settings from the Copy Settings From
drop-down list box.
4. Highlight the configuration(s) in the Copy Settings To field that you want to change.
5. Click Copy .
Debug Menu
Use the Debug menu to access the following functions for the debugger:
•
Connect to Target – see page 121
•
Download Code – see page 122
•
Verify Download – see page 123
•
Stop Debugging – see page 123
•
Reset – see page 123
•
Go – see page 123
•
Run to Cursor – see page 124
•
Break – see page 124
•
Step Into – see page 124
•
Step Over – see page 124
•
Step Out – see page 124
•
Set Next Instruction – see page 124
For more information about the debugger, see the Using the Debugger section on page 385.
Connect to Target
The Connect to Target command starts a debug session using the following process:
1. Initializes the communication to the target hardware.
2. Resets the device.
3. Configures the device using the settings in the Configure Target dialog box.
4. Configures and executes the debugger options selected in the Debugger tab of the
Options dialog box. The following options are ignored if selected:
– Reset to Symbol ‘main’ (Where Applicable) checkbox
– Verify File Downloads – Read After Write checkbox
Note: