Zilog ZAURA868 - Manual (Page 36)

ZAURA RF Module Shell
User Manual
UM023502-0911 sleep
30
sleep Put node to sleep
Syntax
sleep
Example 1
sleep

Going to sleep...

After the sleep command is issued, the ZAURA RF Wireless node is
placed into a low power state. The unit will remain dormant until an
F2480 Stop Mode Recovery event returns the unit to normal mode. When
the
sleep command is issued in the default ZAURA RF Demo program
running on the ZAURA Wireless validation board, pressing the SW1
pushbutton or typing a character on the console terminal will reactivate
the Module. When using the sleep command with a custom project any
GPIO port pin configured as a Stop Mode Recovery source can be used to
reactivate the Module.