Fireplace installation – Desa T32N-a SERIES User Manual

Page 25

Advertising
background image

www.desatech.com

116646-01D

5

9. Follow instructions below to install logs, lava

rock and ember material.

10. Close glass door, lock latches on top and bottom

of door and replace screen (see steps 5 and 6 of

Removing Glass Door, page 24).

11. Close top and bottom louvers.

Figure 44 - Installing Side Brick Panels

Left Side
Brick Panel

FIREplaCE

INSTallaTION

Continued

INSTALLING LOGS, LAVA ROCK
AND GLOWING EMbERS

Each log is marked with a number. These numbers

will help you identify the log when installing. It

is very important to install these logs exactly as

instructed. Do not modify logs. Only use logs

supplied with fireplace.

Open louvers, remove screen, unlock door latches

and open glass door. See steps 1 and 2 of Remov-

ing Glass Door, page 24. Install logs according to

instructions for fireplace model numbers.

1. Place log #1 (rear log) on top of grate. Make

sure the notches in the bottom of the log fit

over the grate (see Figure 45).

2. Rest log #2 (large front log) on the pins on the

front part of the grate (see Figure 46).

3. Place log #3 (crossover log) onto the rear and

front logs. Make sure it is seated properly on

the smooth surface on the front log and on the

pin on the back log as shown in Figure 47.

4. Place log #4 (right log) on the pin on the

right side of front log as shown in Figure

48, page 26.

5. Place log #5 (base log) onto the front left part

of the grate making sure the notches fit over the

prongs of the grate). See Figure 49, page 26.

1

Figure 45 - Installing Log No. 1

2

Figure 46 - Installing Log No. 2

3

Figure 47 - Installing Log No. 3

Advertising
This manual is related to the following products: