Operating fireplace, Fireplace installation – Desa T32N-a SERIES User Manual

Page 26

Advertising
background image

www.desatech.com

116646-01D

6

5

6

Figure 49 - Installing Logs No. 5 and No. 6

FIREplaCE

INSTallaTION

Continued

6. Place log #6 (left log) onto two pins on the left

side of back and front log. See Figure 49.

7. Place lava rock along sides and front of

firebox bottom in areas that are visible only.

It is not necessary to use all of the lava rock

provided.

8. Pull ember material apart into pieces no larger

than a dime. Place these pieces loosely and

sparingly directly onto the exposed section of

the front burner and along the space between

the burner and grate prongs (see Figure 50).

This will create the glowing ember appearance

as the flame touches the ember material. Do

not block air slots by using too much ember

material in one area. It is not necessary to use

all of the ember material provided.

9. Close glass door, lock door latches, replace

screen and close louvers (see steps 5 and 7 of

Removing Glass Door, page 24).

Ember Material

Figure 50 - Placing Ember Material on

Burner

OpERaTING FIREplaCE

FOR YOUR SAFETY

READ bEFORE LIGHTING

WARNING: If you do not fol-

low these instructions exactly,

a fire or explosion may result

causing property damage, per-

sonal injury or loss of life.

A. This appliance is equipped with an ignition

device which automatically lights the pilot.

Do not try to light the pilot by hand.

B. BEFORE LIGHTING smell all around the

appliance area for gas. Be sure to smell next

to the floor because some gas is heavier than

air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch.

• Do not use any phone in your building.

• Immediately call your gas supplier from

a neighbor’s phone. Follow the gas

supplier’s instructions.

• If you cannot reach your gas supplier,

call the fire department.

C. Use only your hand to push in or turn the

gas control knob. Never use tools. If the knob

will not push in or turn by hand, don't try to

repair it, call a qualified service technician.

Force or attempted repair may result in a

fire or explosion.

D. Do not use this appliance if any part has

been under water. Immediately call a

qualified service technician to inspect the

appliance and to replace any part of the

control system and any gas control which

has been under water.

4

Figure 48 - Installing Log No. 4

Advertising
This manual is related to the following products: