Desa T32N-a SERIES - Manual (Page 4)

www.desatech.com 116646-01D 4
SaFETy INFORMaTION
Continued
9. Do not use this fireplace to cook food or burn
paper or other objects.
10. This appliance, when installed, must be electri-
cally grounded in accordance with local codes
or, in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70 or
the Canadian Electrical Code, CSA C22.1.
11. Do not use fireplace if any part has been under
water. Immediately call a qualified service per-
son to arrange for replacement of the unit.
12. Do not operate fireplace if log is broken.
13. Provide adequate clearances around air
openings.
pRODUCT
IDENTIFICaTION
Figure 1 - Direct-Vent Fireplace with
Millivolt Ignition
Glass Door Assembly
ON/OFF/REMOTE Switch
(Optional Installation)
Log
Set
Lava
Rock
Glowing
Embers
Upper Louver Panel
Lower
Louver
Panel
Flue
Collar
Nailing
Flange
Grate
Assembly
Piezo
Ignitor
Control
Valve
Blower Switch
(Optional Installation)
lOCal CODES
Install and use fireplace with care. Follow all local
codes. In the absence to local codes, use the cur-
rent National Fuel Gas Code ANSI Z223.1/NFPA
54* (USA) or the current CSA-B149.1 Installation
Code (Canada).
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
pRODUCT FEaTURES
These are a few facts that can help you understand
and enjoy your direct-vent fireplace:
• The venting system may be routed to the out-
side of your home in several ways. It may vent
through the roof (vertical) or it may vent to an
outside/exterior wall (horizontal). The vent
pipe installation is very important to allow for
proper operation. You must follow the venting
instructions very carefully for either vertical or
horizontal applications.
• This fireplace may be installed in any room of
your house provided all local codes and these
installation instructions are followed.
• This fireplace does not require electricity to
operate.
• Only the blower requires electricity if installed.
If you plan to install the blower at a later date,
outlet must be wired at the bottom of the fire-
place when framing.
• A piezo ignitor and ceramic electrode create
sparks to ignite the pilot light. It does not require
any matches, batteries or any other sources of
ignition to light the pilot.
• Each time you turn on your fireplace, you may
notice some amount of condensation on the in-
side of the fireplace glass. This is normal and will
disappear after 10-20 minutes of operation.
• Your direct-vent gas fireplace system (fireplace
and venting) is a balanced and sealed gas op-
erating unit. It requires approximately 10-20
minutes of operating time before the flame
pattern stabilizes.
• Fireplaces with the suffix of -HA have been
designed to operate at altitudes of 4000 feet
and above.