AMETEK ReFlex Firmware Updates User Manual

Reflex power™ firmware updates

Advertising
background image

Technical Note

ReFlex Power™ Firmware Updates

Document No. M380570-01 Rev B • 1/23/2009

©2008 AMETEK Programmable Power, Inc. • All rights reserved. • AMETEK is a trademark of AMETEK, Inc.

9250 Brown Deer Road, San Diego CA 92121 • Tel: 858-450-0085 • Fax: 858-458-0267 • email:

[email protected]

• Web:

www.programmablepower.com


1 of 2

PURPOSE

Provide instructions for updating firmware on all ReFlex Power

TM

modules.

CAUTION

Review this procedure carefully before attempting the update.

BACKGROUND

ReFlex Power

TM

modules, including the ReFlex Power

TM

Controller (RFPC), Low Power DC (LPDC), High Power DC (HPDC),

AC Power Supply (ACPS), Low Power/High Power Active Loads (LPAL/HPAL), and Fixed Power DC (FPDC) contain embedded
firmware in Flash Memory. The release of ReFlex Power

TM

includes periodic pre-planned feature enhancements implemented

through firmware updates.

PROCEDURE

1. On the Internet, go to

http://www.programmablepower.com/go/rfp_downloads

.

2. In the Software section, click the downloadable for Firmware Update Executable.

3. An RFP Upgrader zip file will pop up; this zip file contains the update Image files, installation programs and instructions.


If the folder is empty, the files may not be available; contact the AMETEK Customer Care Department at

[email protected]

to receive the files.

4. Save this zip and extract the contents to an appropriate location on your computer.

5. Follow the instruction documents carefully.

U

PDATE

I

MAGE

F

ILES

The update Image files contain two types of files “.rbf” and “.bin” files. Below are typical names of the image files. The names
define the type of module, the destination partition and firmware version. The Destination partition defines where the files will be
physically loaded in firmware during the update.

DC:
FPGA Image A: DC_FPGA1_2_000_000.rbf

This is the DC module Field Programmable Gate Array Image 1 version 2.000.000.

FPGA Image B: DC_FPGA2_2_000_000.rbf

This is the DC module Field Programmable Gate Array Image 2, version 2.000.000.

Advertising