ARRIS TM722G-CT User Guide - Manual (Page 62)

Cable Modem Start Up Sequence
The following table shows the start-up sequence for the cable modem portion of the
Telephony Modem. Indicator color is not important.
Using the Reset Button
Use the Reset button, on the back of the Telephony Modem, to reset the modem
as if you power cycled the unit. You may need to reset the Telephony Modem if you
are having problems connecting to the Internet. Using this button will be rare.
Use a pointed non-metallic object to press this button. The photo to the left shows
the location of the Reset button. The Reset button is recessed to prevent acci-
dental resets.
Model TM722S only: The rear panel power switch can also be used to power cycle
the unit.
Booting from Battery
The TM722G supports a “Boot from Battery” feature that allows the Telephony
Modem to begin service without AC power.
To start the TM722G from its battery, follow these steps:
1 If a battery is already installed in the Telephony Modem, remove it.
2 Re-insert the battery into the Telephony Modem (see
Battery Installation
and Replacement (TM722G Only) for details).
3 Press the Reset button; the Power light should turn on immediately.
DS US Online Link Description
Flash Off Off Off Downstream search
On Flash Off Off Downstream found; upstream search
On On Flash Off
Downstream and Upstream found; retrieving setup
information from cable operator
On On On On Ready for service
Touchstone TM722 Telephony Modem User’s Guide
Safety
Getting
Started
Battery
Installation Installation
USB
Drivers
Ethernet
Configuration Usage Troubleshooting Glossary
62
Reset Button
TM722G
TM722A/B
TM722S
Reset Button
Power Switch