Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (June 2014) - Manual (Page 199)

Supported IPMI Commands
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54F) 199
Get component properties 0x2C/0x2D 0x2F
Abort firmware upgrade 0x2C/0x2D 0x30
Initiate upgrade action 0x2C/0x2D 0x31
Upload firmware block 0x2C/0x2D 0x32
Finish firmware upload 0x2C/0x2D 0x33
Get upgrade status 0x2C/0x2D 0x34
Activate firmware 0x2C/0x2D 0x35
Query self-test results 0x2C/0x2D 0x36
Query rollback status 0x2C/0x2D 0x37
Initiate manual rollback 0x2C/0x2D 0x38
Table 8-19 Supported PICMG 3.0 Commands (continued)
Command
NetFn
(Request/Response)
CMD
The firmware upgrade commands supported by the blade are implemented according to
the PICMG HPM.1 Revision 1.0 specification.
The boot block can be updated with PICMG HPM.1 specific commands.