Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (June 2014) - Manual (Page 57)

Hardware Preparation and Installation
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54F) 57
4. Fasten the Cave Creek module to the blade using the four M2.5x 4mm screws.
5. Reinstall the blade into the system as described in Installing and Removing the Blade
on page 58 .
Cave Creek Module Removal
To remove the Cave Creek module:
1. Remove the blade from the system as described in Installing and Removing the Blade
on page 58 .
2. Remove the four screws that holds the Cave Creek module.
Figure 2-4 Cave Creek Module Installation