Auto-Zone Control Systems Prism 2 Graphical Interface Technical Guide (Version 01J) - Manual (Page 10)

STEP 2: JOB-SITE SET-UP
Prism 2 Technical Guide 10
Step 2: Setting Up Job Sites
The second step in the Prism 2 Setup procedure is to program the
specifi c job-site access settings and desired initial displays for each
location.
Click on the < Job-Site> button located on the Top
Toolbar of the Prism 2 Main Screen. The Job Sites
Window will appear. (Figure 2)
NOTE: You must confi gure each of the fi elds in this window for
every one of your job sites.
Job-Site Name:
When you fi rst open the Job Sites Window, the Job-Site Selection
Window will be empty. Click on an empty location. The Job-Site
List # will display the number you have selected. In the Selected
Location fi eld, type a name for your job-site and press
<ENTER> .
Figure 2: Job-Sites Window
Serial Port:
TCP/IP — If you are using TCP/IP communications, leave the
Serial Port field set at “No Port Selected” which is the default.
Serial or USB — If Prism 2 will be connecting directly to a
CommLink through the Serial or USB Port, select the port that you
have connected your CommLink to and enter 0.0.0.0 for the Node
IP Address. COM Port #9 is the maximum port number supported
by Prism, so if your USB port is #10 or higher, you will need to
manually force the port to a lower port number using the Device
Manager found in your Windows
® Control Panel. This procedure
is documented in WattMaster’s CommLink IV and CommLink 5
Technical Guides.
Job-Site Set-Up
Revised 9/25/13