Auto-Zone Control Systems Prism 2 Graphical Interface Technical Guide (Version 01J) - Manual (Page 32)

Prism 2 Technical Guide
32
STEP 11: TENANT OVERRIDE LOGGING
Tenant Override Logging
Step 11: Tenant Override Logging
This is an optional confi guration that allows a building owner to
log the amount of time per month that selected controllers on a
loop have been put into the Unoccupied Override Mode. From
this information, tenants can be billed for additional energy usage
beyond normal Occupied operation.
In order to set up Tenant Override Logging to work with the System
Manager TS, you must have a CommLink and MiniLink Polling
Device installed on your system. The following procedure must be
done for the MiniLink Polling Device on each loop.
In the Loop Selection Window of the Prism
2 Main Screen, select the loop where your
MiniLink Polling Device is located. Then,
in the Unit Selection Window scroll down to
Address 60 - MiniLink PD and click once
on your selection.
Click the < Tenant Logging> option at the top far right of the
Polling Device Setpoints Window. The Tenant Logging Window
will appear.
In the Tenant Logging Window, click the box to the left of each
controller to choose tenant logging for that controller. A check
mark in the box designates that the unit will be polled for Tenant
Logging.
The Polling Device Window will appear.
Click <Setpoints> at the top of the screen. The Polling Device
Setpoints Window will appear.
Revised 8/29/11