Auto-Zone Control Systems Auto-Zone CV & CV-EX Systems Installation & Operation (Version 01C) - Manual (Page 54)

Section 3 Auto-Zone CV & CV-EX
3-10 Programming
Read/Reset Units
Read/Reset Address Entry
Read/Reset
[ Enter Unit ID# ]
Selected Unit: 101
You must know the Unit ID of the controller you wish to view.
This number is created by combining the network loop address
with the CV Controller board address on CV-EX systems. On
CV systems, the Unit ID is simply the CV controller board
address. The CV Controllers should always be addressed
starting with number 1 and continuing up to 30. The CV-EX
MiniLinks (network loop address) should be numbered starting
with 1 and continuing up to 4 (assuming you have 4 loops).
Don’t skip numbers.
Once you have finished the Read/Reset function, you can exit
this mode by pressing the ESC key. This will return you to the
Full Access Menu.