Avalon Firestyles Extra Room Power Heat Duct - Manual (Page 10)

Extra Room Power Heat Duct Instructions
SKU 98500769
Page 10 of 11 12/2/13 - 17601067 © Travis Industries, Inc.
Fireplace Wiring – Xtreme 6020
The Xtreme 6020 is pre-wired for use with the power heat duct. Route the wire from the blower to the
junction box on the fireplace. The wire pases through both cover plates (use the included strain relief on
the inner plate). Attach the wire to the supplied molex connector using wire nuts. Then connect the
molex connector to the connector on the fireplace (see the arrow below). The blower is controlled by
the fan control module inside the fireplace using the included remote control (the blower rheostat is not
used).
Fireplace Wiring – 36 CF ST/Pier & 1080 CF (use sku 94400995 )
See the instructions included with the 36 CF ST/Pier & 1080 Wiring kit (sku 94400995). The wire from
the rheostat is routed to the fireplace where it is controlled by the fireplace 110v circuit.