Baby Lock Crescendo (BLCR) Instruction and Reference Guide - Manual (Page 59)

USING FUNCTIONS BY CONNECTING THE ACCESSORY TO THE MACHINE
G
ettin
g R
ea
d
y
Basic operations B-57
B
1
■ Replacing the Sole Part of the Dual
Feed Foot
If you push down on the front part of the dual feed
foot, the sole part of the dual feed foot will snap off.
Attach the sole by aligning the pins with the notches
and snap it into place.
a Pins
b Notches
■ Using the Dual Feed Position Lever
When the feed position lever is up, the black roller
belt on the dual feed is not engaged.
When the feed position lever is down, the black
roller belt on the dual feed is engaged.
■ Adjusting the Amount of Fabric
Feeding of the Dual Feed Foot
The dual feed mechanism pulls the top fabric
according to the set stitch length. With troublesome
fabrics, fine tune the set length, by changing the
dual feed feed adjustment in the settings screen.
a
Press .
→ The settings screen appears.
b
Display page 1 of the settings screen.
Note
• Do not operate the lever while sewing.
Note
• As a default, some keys mentioned in the
following procedures appear in light gray
and are not available. To enable the keys for
specifying the settings, attach the dual feed
foot and connector to the machine. The
keys are enabled after the dual feed foot is
detected.