Dish Network DuoDVR ViP 722_TOC - Manual (Page 23)

Remote Controls
77
Controlling Other Components
Setting Up Using Device Codes Scan
If the code for your device is not listed in the tables starting on page 132 or if you could not find a
code that worked for your device, use this procedure to scan the remote control’s memory for the
device code. In the instructions below, the column on the left contains the instructions and the
column on the right provides additional information.
Instructions Additional Information
1. Turn the device on. Use the device’s front panel buttons or its remote control.
2. Press and hold the mode button until all the
other mode buttons light up, and then
release the button. The mode button
flashes. For example, hold the TV mode button until all of the other
mode buttons light. When you let go, TV will flash.
3. For AUX mode only. Press 0 for TV, 1 for
VCR, or 2 for a tuner, or amplifier. Then
press the STAR (*) button. This step is for programming the type of device that will be
programmed in AUX mode. If you’re not programming in
AUX mode, skip to step 4.
4. Press POWER. This puts your remote in the scan mode.
Instructions Additional Information
5. Press the UP or DOWN ARROW
repeatedly until the device turns off. As you press the UP or DOWN ARROW , the remote
tries each code in the memory to see if it can turn off your
device. When the device turns off, you have found a code
that might work.
Note: The mode button for the device will flash rapidly eight
times when you’ve scanned all the codes for that device.
6. Press POUND (#). The mode button flashes three times if you have entered
the code correctly, and stores the code you found.
7. Turn the device back on and try some other
buttons to make sure they work. Sometimes POWER works when other buttons don’t. If
using Limited Mode, try VOLUME or MUTE.
8. If necessary, repeat this procedure until
you’ve tried all the codes. You may need to repeat the scan to find the best code for
your device.
1
2-3
4
6
5
7-8
Turn
device on
Press
POWER
Turn device back on
and test to make
sure code works
Press & hold
Mode button
until all Mode
buttons light up
VCR
#
Press UP or
DOWN ARROW
until device
turns off
Press
POUND
VCR
VCR